When you first use the new UFI eMMC Adapter, sometimes some pins are found that lost contact, or not properly connected.
This usually happens because during the delivery, it may be that the pin has shifted, or it is not perfectly connected. To solve this problem, please refer to the following video.
Good
Thnkss
thanks
if we don't have adapter or for example it was broken.
can we just solder the 5 wires vcc, vccq, cmd,clk,dat0 and we can install fix emcp?
winpinph
winpinph bro u try this way direct solder to chip is it working?
winpinph You can make direct jumper to emmc, but you have pay attention to pull up resistor from vccq to cmd, and dat0 line. Just to remind, when make adapter, don't forget to give Pull Up resistorr 100Ohm for DAT0 and CMD to VCCQ 1,8V.
madgoeslim sir you can send digram or scath dra for dirk emmc conetin
madgoeslim thanks sir i got a new bga221 adeptar thanks a lot
arifzaman may emmc adaper not work
Rizan114u You are welcome. Nice to hear you solve the problem.
