replace emmc smartfren i46d1g

RiiRamadhan

i was replace emmc smartfren i46D1G using KMQ72, but the phone still not booting...
the phone was detected as Qualcom QDloader 9009 and succesfull identify using UFI Android Toolbox...

This log of UFI:

Scanning for Qualcomm HS-USB QDLoader 9008 device...
Download Port: Qualcomm HS-USB QDLoader 9008 (COM26)
USB Driver: [Qualcomm Incorporated] qcusbser, version: 2.1.2.0, date: 7-8-2015
Initializing... Done.
MSM Serial number: 0x0cfb4cf9
MSM HW ID: 0x007050e1
OEM Public Key Hash: 0xcc3153a80293939b90d02d3bf8b23e0292e452fef662c74998421adad42a380f
SBL SW version: 0
Sending prog_emmc_firehose_8916.mbn, size: 90.98 KiB... Done.
Attempting to run firehose... Done.
Sending ping... Done.
Sending configurations...
TargetName: 8916
MemoryName: eMMC
Version: 1
Firehose configured.
Capacity: 7.29 GiB(7,824,474,112 bytes)
Boot1: 2048 KiB
Boot2: 2048 KiB
RPMB: 2048 KiB
User area: 7.28 GiB(7,818,182,656 bytes)

platform: msm8916, cpu abi: armeabi-v7a
manufacturer: Hisense
board: msm8916, name: I46D1G
brand: Smartfren, model: Andromax I46D1G
build id: LRX22G, version: 5.0.2 Lollipop (LRX22G release-keys)
build description: I46D1G-user 5.0.2 LRX22G L1074L.6.02.01 release-keys

crypto state: encrypted

Any suggestion?

madgoeslim

RiiRamadhan as Qualcom QDloader 9009

This is 9009 or 9008?
Seems like eMCP already installed properly to PCB, and rom successfully written to chip.
But this is from Nand area, we can make sure the condition of lpddr inside eMCP.
If lpddr is not good, device will stuck at 9008.
So first try use another chip. If problem remain, this could be also defect soldering ball of SoC, and some case, PMU too.

RiiRamadhan

madgoeslim oh sorry Mr, 9008...
i try to flash but error writing at "grow" partition..
when the phone turning on using power suply, the current displayed 0.5-0.6 Amper stuck, and the Emmc hot..
this emmc check using UFI seems normal,
i was try to use the same emmc to other phone (J1 Ace), the problem is same

madgoeslim

RiiRamadhan Emmc hot

You can do flash, means device is in working state, exept emcp. Then do check at all the emcp pins in PCB using multimeter, maybe some short pins exist there that cause emmc become hot.