hello
guys i am beginner in jetag and emmc >
problem here when i want to connect it always give me CLK not properly connected
and try to remove solder and solder it again same thing and isp take it from ufi
i want to know where is the problem and also search about this found many thing i dont understand
plz guide me and if there is another picture isp plz give it to me
Connection status: EHCI:HUB:HUB:USB 2.0 High-Speed
Interface: UFI High-Speed
Serial number:
Boot version: 1.04, FW version: 1.12 (Jun 7 2018 00:06:47)
Insertion test... CLK not properly connected
Init bus...
VCC: 2.8 V, VCCQ: 1.8 V
Failed to initialize eMMC (return code: 17, CMD Error: Timeout) !!!
CMD1 error, cmd response: 0x0, card state: 255 (Card is in unknown state)
SEND_OP_COND command failed.
--- Check eMMC pins and connection ---
--- Try to select correct VCC/VCCQ manually ---
--- Try to decrease the clock speed ---
