Samsung P3100 product name 000000 help

shady

VCC: 3.3 V, VCCQ: 1.8 V
Bus: 1 bit (SDR 4MHz)
Access mode: sector mode
Power supply: dual-voltage (1.70-1.95V, 2.7-3.6V)
Card/BGA: BGA (Discrete embedded) - High density MMC
Manufacturer ID: 0x15 (Samsung)
Product name: 000000 (0x303030303030), rev: 0x56, serial number: 0x20110726
Manufacturing date: Jul 2011
CID: 15010030 30303030 30562011 0726589C
CSD: 90270132 0F5903FF F6DBFFEF 8A404022
EXT_CSD revision: 1.5 (MMC v4.41)
Partition info:
Boot1: 512 KiB
Boot2: 512 KiB
RPMB: 128 KiB
User area: 16 GiB(17,179,869,184 bytes)
Partition configuration: 0x00
No boot acknowledge is sent (default)
Device is not boot-enabled (default)
Partitioning support: 0x03
Device support partitioning feature
Device can have enhanced technological features
Device partitioning possible
Boot configuration protection: 0x00
Boot bus conditions: 0x00
Boot area write protection: 0x00
Power-on write protection: possible
Permanent write protection: possible
Lock status: not locked
moviNAND: card is run in boot mode.

shady

when i try to update emmc fw gt this error
VCC: 3.3 V, VCCQ: 1.8 V
Bus: 1 bit (SDR 1MHz)
Access mode: sector mode
Power supply: dual-voltage (1.70-1.95V, 2.7-3.6V)
Card/BGA: BGA (Discrete embedded) - High density MMC
Manufacturer ID: 0x15 (Samsung)
Product name: 000000 (0x303030303030), rev: 0x56, serial number: 0x20110726
Manufacturing date: Jul 2011
CID: 15010030 30303030 30562011 0726589C
CSD: 90270132 0F5903FF F6DBFFEF 8A404022
EXT_CSD revision: 1.5 (MMC v4.41)
Partition info:
Boot1: 512 KiB
Boot2: 512 KiB
RPMB: 128 KiB
User area: 16 GiB(17,179,869,184 bytes)

moviNAND Field firmware update...
Part name: KLMAG2GE4A-A002
Product name: MAG2GA (0x4d4147324741), rev: 0x07
You may disconnect the emergency boot mode TP now !
Switch to boot mode(2)... Done.
Sending firmware, size: 128 KiB... send failed at offset: 0x00010000

elpring

must replace withe new one bro

shady

Set Done after installing ufi v1.2.0.399 setup