SM-P5200 DEAD BOOT

helpo

HI
i have this phone when connceting to pc reconized as colorview

so>
i connect the isp and when i make identify it give me
Connection status: EHCI:HUB:HUB:USB 2.0 High-Speed
Interface: UFI High-Speed
Serial number:
Boot version: 1.04, FW version: 1.12 (Jun 7 2018 00:06:47)
Insertion test...
Error: VCCQ overcurrent detected !!!
Aborted
i want to explain you know adaptor for box and check lamp it still lighting for seconeds then off and i measure the values for vcc-and vccq 2.9-1.8 after seconds off is the wires when they touch each other not connnecting >>>i need answer plz

helpo

when i disconnect The usb now give me this
Connection status: EHCI:HUB:HUB:USB 2.0 High-Speed
Interface: UFI High-Speed
Serial number:
Boot version: 1.04, FW version: 1.12 (Jun 7 2018 00:06:47)
Insertion test... DAT0 not properly connected
Init bus...
VCC: 3.3 V, VCCQ: 3.0 V
Failed to initialize eMMC (return code: 226, Over current detected) !!!
Check your connection, make sure eMMC inserted properly.

Jeremmi

at the isp from ufi's always the problem...remove emmc, put on the pad. On support there are files, yesterday I had such device...replaced the emmc with no problems, everything is OK.