Failed to initialize eMMC (return code: 17, CMD Error: Timeout) !!!

shady

Always get this error on some Samsung And Oppo phone while direct emmc (isp)
phone is on but cannot connect pls help

Failed to initialize eMMC (return code: 17, CMD Error: Timeout) !!!
CMD1 error, cmd response: 0x0, card state: 255 (Card is in unknown state)
SEND_OP_COND command failed.
--- Check eMMC pins and connection ---
--- Try to select correct VCC/VCCQ manually ---
--- Try to decrease the clock speed ---

eross

try a little harder, make sure your wiring is good, u can also try with change voltage or clock value manually.

Chennai

almost error:

Shiva

Connection status: EHCI:HUB:USB 2.00 High-Speed
Interface: UFI High-Speed
Serial number:
Boot version: 1.04, FW version: 1.13 (Aug 19 2019 23:46:09)
Insertion test... Done
VCCQ not properly connected
Init bus...
VCC: 3.3 V, VCCQ: 1.8 V
Failed to initialize eMMC (return code: 17, CMD Error: Timeout) !!!
CMD1 error, cmd response: 0x0, card state: 255 (Card is in unknown state)
SEND_OP_COND command failed.
--- Check eMMC pins and connection ---
--- Try to select correct VCC/VCCQ manually ---
--- Try to decrease the clock speed ---

Ghulampasha

seem eror plz help me

Ghulampasha

ufi isp adapter v2

rohit50

USE usb cable for vcc and vccq when press identify press phone power button and apply 2 time ground to pcb

Mobin

recheck all connections and try again mostly check cmd pin its will be done

Sweetsonu984

I also facing same problem
I did not find any solved solution

Kindly please help me

mangu

Connection status: VUSB3HUB:VUSB3HUB:USB 2.00 High-Speed
Interface: UFI High-Speed
Serial number: 0011-8842-0878
Boot version: 1.05, FW version: 1.13 (Aug 19 2019 23:46:09)
Insertion test... Done
Init bus...
VCC: 3.3 V, VCCQ: 1.8 V
Failed to initialize eMMC (return code: 17, CMD Error: Timeout) !!!
CMD1 error, cmd response: 0x0, card state: 255 (Card is in unknown state)
SEND_OP_COND command failed.
--- Check eMMC pins and connection ---
--- Try to select correct VCC/VCCQ manually ---
--- Try to decrease the clock speed ---

qroy

i same cases please