Connection status: IUSB3HUB:USB 2.00 High-Speed
Interface: UFI High-Speed
Serial number: 0011-8840-8598
Boot version: 1.04, FW version: 1.13 (Aug 19 2019 23:46:09)
Insertion test... Done
VCC, VCCQ not properly connected
Init bus...
VCC: 3.3 V, VCCQ: 1.8 V
Bus: 1 bit (SDR 4MHz)
Access mode: sector mode
Power supply: dual-voltage (1.70-1.95V, 2.7-3.6V)
Card/BGA: BGA (Discrete embedded) - High density MMC
Manufacturer ID: 0x90 (SK Hynix)
Product name: H4G2b (0x483447326211), rev: 0x01, serial number: 0x5789C453
Manufacturing date: فوريه 2017
CID: 90014A48 34473262 11015789 C4532430
CSD: D07F0132 0F5903FF FFFFFFEF 8A4040DA
EXT_CSD revision: 1.6 (MMC v4.5, v4.51)
Partition info:
Boot1: 4096 KiB
Boot2: 4096 KiB
RPMB: 4096 KiB
User area: 3.64 GiB(3,909,091,328 bytes)
Cache size: 512 KiB
Partition configuration: 0x08
No boot acknowledge is sent (default)
Boot partition 1 is enabled for boot
Partitioning support: 0x07
Device support partitioning feature
Device can have enhanced technological features
Device partitioning possible
Boot configuration protection: 0x00
Boot bus conditions: 0x00
Boot area write protection: 0x00
Power-on write protection: possible
Permanent write protection: possible
Lock status: not locked
Selected: [HYNIX] eNAND H9TP32A4GDDCPR-KGM/4GB (BGA162)
I have pasted all the files correctly but I will not find any partitions after the operation is completed! Why?