Hi. Anyone was struggling with this error?
Writing mmcblk0p1 at 0x00100000-0x00CFFFFF (24576 sectors)... Failed to write block 0x00100000:65536 (return code: 1, CMD Error: Timeout)
cmd response: 0x900, card status: 0x0, card state: 4 (Card is in transfer state)
status: unknown (0)
Read always ok. But can not write anything.
eMMC ident:
VCC: 3.3 V, VCCQ: 1.8 V
Bus: 1 bit (SDR 48MHz)
Access mode: sector mode
Power supply: dual-voltage (1.70-1.95V, 2.7-3.6V)
Card/BGA: BGA (Discrete embedded) - High density MMC
Manufacturer ID: 0x11 (Toshiba)
Product name: 032G34 (0x303332473334), rev: 0x04, serial number: 0xAA54C2E8
Manufacturing date: wrz 2019
CID: 11010030 33324733 3404AA54 C2E896FE
CSD: D0270032 8F5903FF FFFFFFE7 864000A6
Firmware version: 0x2
EXT_CSD revision: 1.8 (MMC v5.1)
Partition info:
Boot1: 8 MiB
Boot2: 8 MiB
RPMB: 4 MiB [Authentication Key not yet programmed]
User area: 29.12 GiB(31,268,536,320 bytes)
Cache size: 4 MiB
Hardware reset function: 1
Secure Write Protect Information: 0x01
Secure Feature support: 0x55
Partition configuration: 0x00
No boot acknowledge is sent (default)
Device is not boot-enabled (default)
Partitioning support: 0x07
Device support partitioning feature
Device can have enhanced technological features
Device partitioning possible
Boot configuration protection: 0x00
Boot bus conditions: 0x00
Boot area write protection: 0x00
eMMC selected: [TOSHIBA] THGBMHG8C4LBAIR/32GB (BGA153)
