IM Trying to revived this dead phone, did I connect properly my wire or not? IM confused where to connect vcc & vccq. In picture I see 3.3v & 2.8v. Rest I connected dat0, cmd, clk. Do you have pic for this pba where exactly I connect VCC &VCCQ?
Here is my log:
Connection status: EHCI:HUB:HUB:USB 2.00 High-Speed
Interface: UFI High-Speed
Serial number: 0011-xxxx-xxxx
Boot version: 1.04, FW version: 1.10 (Mar 26 2017 14:24:34)
Insertion test... Done.
VCCQ not properly connected
Init bus...
VCC: 3.3 V, VCCQ: 2.8 V
Failed to initialize eMMC (return code: 6, CMD Error: Invalid Voltage Range) !!!
CMD1 error, cmd response: 0xFF8080, card state: 255 (Card is in unknown state)
SEND_OP_COND command failed.
--- Card might be DEAD, for some moviNAND(Samsung) devices you may update the eMMC firmware by TP[ \TestPoint ] ! ---
Regards,
