oppo a5s cph1909 dead after factory resat with ufi
alradey try remove clk take jumper but not done
Connection status: EHCI:HUB:HUB:USB 2.0 High-Speed
Interface: UFI High-Speed
Serial number: 0011-8841-0657
Boot version: 1.04, FW version: 1.12 (Jun 7 2018 00:06:47)
Insertion test... Done.
VCCQ not properly connected
Init bus...
VCC: 3.3 V, VCCQ: 1.8 V
Bus: 1 bit (SDR 4MHz)
Access mode: sector mode
Power supply: dual-voltage (1.70-1.95V, 2.7-3.6V)
Card/BGA: BGA (Discrete embedded) - High density MMC
Manufacturer ID: 0x15 (Samsung)
Product name: QD63MB (0x514436334d42), rev: 0x03, serial number: 0xCB90AA9D
Manufacturing date: Feb 2019
CID: 15010051 4436334D 4203CB90 AA9D2696
CSD: D0270132 0F5903FF F6DBFFEF 8E40400C
EXT_CSD revision: 1.8 (MMC v5.1)
Partition info:
Boot1: 4096 KiB
Boot2: 4096 KiB
RPMB: 16384 KiB
User area: 29.12 GiB(31,268,536,320 bytes)
Cache size: 64 MiB
Hardware reset function: 1
Partition configuration: 0x00
No boot acknowledge is sent (default)
Device is not boot-enabled (default)
Partitioning support: 0x07
Device support partitioning feature
Device can have enhanced technological features
Device partitioning possible
Boot configuration protection: 0x00
Boot bus conditions: 0x02
Bus width: x8 (sdr/ddr), boot mode: sdr(default), reset bus width to x1 sdr(default)
Boot area write protection: 0x00
Power-on write protection: possible
Permanent write protection: possible
Lock status: not locked
ANDROID System Info:
platform: MT6765, cpu abi: arm64-v8a
manufacturer: OPPO
board: CPH1909, name: CPH1909
brand: OPPO, model: CPH1909(OPPO A5s)
build id: O11019, version: 8.1.0 Oreo (CPH1909EX_11_A.20)
build description: full_oppo6765_18511-user 8.1.0 O11019 1554009363 release-keys
Internal storage: 22.40 GiB
crypto state: unencrypted
Custom moviNAND command is not supported for this device(MMC51).
Detected: SAMSUNG moviNAND KMQD60003M-BXXX/32G
