I can't do anything with this card
Connection status: XHCI:HUB3:[#0]:USB 2.00 High-Speed
Interface: UFI High-Speed
Serial number: 0011-8842-5714
Boot version: 1.05, FW version: 1.13 (Aug 19 2019 23:46:09)
Insertion test... Done
Init bus...
VCC: 2.8 V, VCCQ: 1.8 V
Bus: 8 bit (SDR 16MHz)
Access mode: sector mode
Power supply: dual-voltage (1.70-1.95V, 2.7-3.6V)
Card/BGA: BGA (Discrete embedded) - High density MMC
Manufacturer ID: 0x15 (Samsung)
Product name: RX1BMB (0x525831424d42), rev: 0x07, serial number: 0xD59BDE47
Manufacturing date: Jan 2017
CID: 15010052 5831424D 4207D59B DE47143E
CSD: D0270132 0F5903FF F6DBFFEF 8E40400C
EXT_CSD revision: 1.8 (MMC v5.1)
Partition info:
Boot1: 4 MiB
Boot2: 4 MiB
RPMB: 4 MiB [Authentication Key not yet programmed]
User area: 29.12 GiB(31,268,536,320 bytes)
Cache size: 64 MiB
Hardware reset function: 1
Partition configuration: 0x38
No boot acknowledge is sent (default)
User area is enabled for boot
Partitioning support: 0x07
Device support partitioning feature
Device can have enhanced technological features
Device partitioning possible
Boot configuration protection: 0x00
Boot bus conditions: 0x00
Boot area write protection: 0x00
Custom moviNAND command is not supported for this device(MMC51).
Selected: [SAMSUNG] KMRX1000BM-B614/32GB+LPDDR3 24Gb (BGA221)
eMMC 5.x Health report:
Device lifetime: Normal
Estimation of the device lifetime (SLC): Exceeded its maximum estimated device life time
Estimation of the device lifetime (MLC): Exceeded its maximum estimated device life time
Failed to read block 0x00200000:512 (return code: 1, CMD Error: Timeout)
cmd response: 0x900, card status: 0x0, card state: 4 (Card is in transfer state)
status: unknown (0)
--- Make sure the connection between BOX and eMMC stable ---
--- please try again (you may RESUME the read process) ---
Failed to read block 0x00000000:512 (return code: 1, CMD Error: Timeout)
cmd response: 0x900, card status: 0x0, card state: 4 (Card is in transfer state)
status: unknown (0)
--- Make sure the connection between BOX and eMMC stable ---
--- please try again (you may RESUME the read process) ---
Factory erase... failed!
Reseting PART_CONFIG... [179]Failed to Switch (return code: 1, CMD Error: Timeout) !!!
failed!
Reseting BOOT_BUS_CONDITIONS... [177]Failed to Switch (return code: 1, CMD Error: Timeout) !!!
failed!
Writing eMMC partition settings...
Set general purpose partition... Done
Set write reliability setting... Cannot set write reliability parameters, WR_REL_SET in this device is read-only.
Could not write 1F to EXT_CSD[167]
Set OTP Partitioning setting completed... failed!
