hello, ufi recognizes a Samsung A042M, but it does not load its partitions, the device turns on normally.
VCC: 2.8 V, VCCQ: 1.8 V
Bus: 1 bit (SDR 24MHz)
Access mode: sector mode
Power supply: dual-voltage (1.70-1.95V, 2.7-3.6V)
Card/BGA: BGA (Discrete embedded) - High density MMC
Manufacturer ID: 0x15 (Samsung)
Product name: DX68MB (0x445836384d42), rev: 0x00, serial number: 0xDA06902B
Manufacturing date: nov. 2022
CID: 15010044 5836384D 4200DA06 902BB96A
CSD: D0270132 0F5903FF F6DBFFEF 8E40400C
Firmware version: 0x04
EXT_CSD revision: 1.8 (MMC v5.1)
Partition info:
Boot1: 4 MiB
Boot2: 4 MiB
RPMB: 16 MiB [Provisioned, counter: 4420]
User area: 29.12 GiB(31,268,536,320 bytes)
Cache size: 64 MiB
Hardware reset function: 1
Secure Write Protect Information: 0x01
Secure Feature support: 0x55
Partition configuration: 0x48
Boot acknowledge is sent during the boot operation
Boot partition 1 is enabled for boot
Partitioning support: 0x07
Device support partitioning feature
Device can have enhanced technological features
Device partitioning possible
Boot configuration protection: 0x00
Boot bus conditions: 0x02
Bus width: x8 (sdr/ddr), boot mode: sdr(default), reset bus width to x1 sdr(default)
Boot area write protection: 0x00
eMMC selected: [SAMSUNG] KMDX60018M-B425/32GB+LPDDR4X 24Gb (BGA254)
