Since the release of UFI version 1.2.0.411, we already support for SLA auth of Meizu Devices.
Especially for Mediatek devices, now you can be treated as General Mediatek Devices.
Whether it's for flashing, read or write partitions, rewrite imei, clear user lock, also for Clear Flyme Account.
We have the case Meizu M2 (M88) hang on logo, try to flash again, but failed with the description as shown in the picture.
Visible area of emmc Nand is not healthy, so we continue processing via eMCP replacement using UFI eMMC ToolBox.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Set up an eMCP replacement with UFI eMMC ToolBox
We using new eMCP Chip Samsung KMR310001M-B611 (16/2)
Remember to always "Identify eMMC" first before any other operation
1. "Factory Reset" eMCP
For eMMC samsung with Ext_CSD rev. below 1.8, it will erase Nand Area, and reset configuration setting emmc to original state.
2. Checking "NAND Test"
We Added read & write sector 0 before random test in other area.
It should be more precise to check quickly Nand area
3. Load Firmware in Factory Image
Let's see the List of supported eMCP by preloader for this Device.
Incidentally eMCP replacement CID was not in the list.
Copy eMCP CID which is in preloader support firmware, and write CID to eMCP Replacement.
4. eMCP CID now Changed
For Mediatek Devices, you don't need to always manually set up the configuration of eMCP.
As long as CID eMCP supported by preloader, eMCP config will auto set during Flashing Procedure.
Let installed eMCP replacement to the board without any config.
It's Flashing time using UFI Android ToolBox
5. Before Flashing Meizu devices, make sure the PC is connected to the Internet Connection.
Check Server Status, Make sure SERVER AUX one, or both ONLINE.
About Server Status :
- MAIN = Registration, Activation Server
- SUPPORT = Data File Download Server
- AUX = Auxiliary Server
6. Then select the correct Brand, Platform, Model, and Firmware.
Always Remember this. Different Brand, Model, and Platform have their own Special Task.
Wait for device to turn on, long enough, prepare a cup of coffee while waiting ;-)
7 Repair Imei via AT-mode
After the Device is fully ON, enable USB Debugging, Dial *#*#3646633 #*#,*enable ATCI to write Imei.
Select port, write Original Imei via Checklist AT Mode.
Complete with the old method can be found here: https://ufixers.com/d/14-hardbrick-meizu-m2-m88-replace-emmc
Congratulations, we just revived the Meizu M2 with a new method via UFI Box.
